View Single Post
boyt911sc boyt911sc is offline
Registered User
Join Date: Mar 2002
Location: Philadelphia, PA
Posts: 9,060
Fuel flow tests.........


Letís simplify the test procedure:
1). Remove all the six (6) fuel injectors from the fuel lines.
2). Place the fuel lines (less injectors) in separate containers. Secure the containers.
3). Test run the FP using the FP relay socket by bridging terminals #87a & 30 with the ignition switch @ ON position not START.

The fuel pump should run and build up fuel pressure in the system. There should be no fuel coming out from the fuel lines or continuous drips. To test the fuel flow, lift up the sensor plate for several seconds and observe each fuel line flow rate or volume.

PM me if you have any question regarding the procedure. Do not buy any fuel injector/s until you have tested and confirm they are defective. Unless you just want to spend your money. Keep us posted.

Old 06-03-2018, 07:46 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #7 (permalink)