View Single Post
Snitzler Snitzler is offline
Registered
 
Join Date: Feb 2013
Location: Winnipeg, Manitoba
Posts: 351
I just replaced both of my window seals. Both sides had gaps at the front of about .25" which let in water, lots of water. Fortunately, it was easier than expected. I pried up the trim with a plastic trim tool. The old seals pulled out of the trim pieces easily. Inserting the new seals was difficult until I figured to pull the seal into the slot rather than pushing. I didn't need any lube but it did become rather difficult when the seals were almost in, I had to pull and push along the length of the seal at the same time. The seal was too long but since it is rubber, it compressed so that the ends were preloaded which made for a great fit. Putting the trim back in was easy I just used the side of my fist to push the trim back in. Both sides took about 15 minutes in total.





__________________
1988 Carrera coupe
1966 250 Ducati
2015 VW Golf TDI gone because Dieselgate!
2017 VW Golf TSI
Old 08-17-2018, 06:15 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #7 (permalink)