View Single Post
GHEN GHEN is offline
Join Date: Jan 2004
Location: Gahanna, Ohio
Posts: 559
Originally Posted by pfarah View Post
Actually Ghen, it's very easy.
1. Simply remove the bulb
2. Set your Volt/Ohm meter to DC volts (20vdc or thereabouts)
3. Turn your car's light switch on (parking works)
4. Place the red meter lead on the center contact in the light socket (Positive/Hot)
5. Place the black lead on the socket's side (Negative/Ground)
6. Read the results - You should see a value of 11.5 - 13.0vdc; any reading will prove that there is continuity.

Note: Try not to touch the leads together; you'll end up blowing a fuse/relay. Good luck!
Thanks, I'm going to try this now!

'87 944
Old 11-28-2019, 06:31 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #8 (permalink)