View Single Post
MikeB MikeB is offline
Registered User
 
Join Date: Nov 2001
Location: San Antonio, TX
Posts: 250
Turk
I forgot to mention that I had already tried that. In fact, I had the clamp tightened as far as it would go. But, since I had nothing to lose and the fact that I was going to replace that line anyway, I got ugly with it and used vice grips on it as a test.

Golden, 5 psi. So, I am going to replace the line and use a piece of the scrap line to shim the clamp so I can get it tight enough for 3.5 psi.

Sure doesn't make any sense as to why this line is 5/16 ID when you have to close it a ton to get any pressure. I might try 1.4 ID...
Old 01-01-2004, 03:52 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #3 (permalink)