View Single Post
Gabe. Gabe. is offline
Registered
 
Join Date: Mar 2011
Location: Los Angeles
Posts: 204
Quote:
Originally Posted by Mr Beau View Post
Ed Pink must have had their dyno tach setting configured for an 8 cylinder engine instead of 6, hence the low RPM. If using the Dynojet software I don't think this would affect the horsepower numbers, but I don't know about their system. (Torque would be higher if the RPM was off, but not HP).

Does your VE table at 100% TPS approximately follow what the torque curve of your engine should be?
Quote:
Originally Posted by Mr Beau View Post
I haven't use Megasquirt too much, but is your rev limit capped to 6000 RPM by coolant temp?
No, that feature isn't turned on.

I'd say that the VE table loosely follows the torque curve but then trends back up towards 7k rpm. Here's my current VE table:



And the log of the last dyno run shows it maxed at 6,930 RPM

__________________
Instagram @everythingcrafted
Day Job - Crafted Wealth
www.craftedwealthmanagement.com
Old 11-21-2020, 09:27 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #266 (permalink)