View Single Post
sayah sayah is offline
Registered User
 
sayah's Avatar
 
Join Date: Apr 2002
Location: new york, new york
Posts: 150
This can't be rocket science, first look into using the inserts in Enco Catalogue, pp. 658 & 659.

Next, find or make a jig as a drill guide. This can't be too hard since the jib could be made big enough to bolt into the other existing fastners on th engine and supported quite flat on the case spigots. Check the depth so you don't drill so deep as to go through the case. Make sure the studs you are using will hold the loads from combustion.

One problem: it might be hard to find metric inserts but I think the differences between metric and US standards will fall in acceptable tolerance limits.
__________________
sayah
Old 06-11-2004, 03:50 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #16 (permalink)