View Single Post
Bobboloo Bobboloo is offline
Warren Hall Student
 
Bobboloo's Avatar
 
Join Date: Aug 2000
Location: Los Angeles Ca.USA
Posts: 3,959
Garage
I know I'm a bit late to this thread but I just wanted to suggest that you make sure that the steel lines from the injection pump to the injectors are torqued properly. If they aren't you loose pressure and then the injector will not open to spray fuel.

Being that everything was fine when you took the induction off I would check this before digging into the pump guessing that it might have laquered up.

I did a rebuild on a 2.4T and set the pump aside longer than you did and it stumbled a little at 3k when I first ran the motor but it evened out after a few days.
__________________
Bobby

Warren Hall 1950 - 2008
_____"Early_S_Man"_____
Old 03-25-2005, 01:36 AM
  Pelican Parts Technical Article Directory    Reply With Quote #9 (permalink)