Thread: 964 deck height
View Single Post
stevepaa stevepaa is offline
Registered User
stevepaa's Avatar
Join Date: Dec 2004
Location: san jose
Posts: 4,980
Okay, the solder method is good but not required for a 964. The OD of the piston is greater than the OD of the dome cut into the head. So you can just measure at the flat on the edge of the piston. Both solder and gauge are now giving me 0.76 mm of deck height. My machinist took off about .5 mm when he made all the heads the same total height and flat.

So do I need to get a custom shim to go between the cylinders and case?
old rocket inguneer
Old 04-02-2005, 11:51 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #4 (permalink)