View Single Post
stevepaa stevepaa is offline
Registered User
stevepaa's Avatar
Join Date: Dec 2004
Location: san jose
Posts: 4,980
There isn't. But my tops of the my cylinders were cut .018 inch to plane and make them all the same height, and my heads were cleaned up .002 inch. So I had a deck heigth of .031 inch. A little too close, and the expert opinion was either to add a single piece base shim or recess cut my heads. Jerry Woods made the shims and so I will give this a shot.
old rocket inguneer
Old 04-18-2005, 01:50 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #5 (permalink)