View Single Post
snowman snowman is offline
Banned
 
snowman's Avatar
 
Join Date: Feb 2003
Location: So California
Posts: 3,787
My point is you are NOT leaving ANY HP on the table. YOu have 800HP heads on a 600HP engine. Why not back off on an obvious extreem wear factor and match the heads to the job at hand?

Actually you have 800 HP heads at 0.4" lift, so say again why you need -.5" lift?

And if you up the boost enough you to can do what BMW did with a 1.6L 4 cylinder engine and get over 1300 HP.

Last edited by snowman; 04-19-2005 at 10:46 PM..
Old 04-19-2005, 09:42 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #162 (permalink)