View Single Post
350HP930 350HP930 is offline
Registered User
 
350HP930's Avatar
 
Join Date: Jun 2003
Location: St Petersburg, FL
Posts: 3,814
We have a shot peening machine at work but I have decided not to use it on any of my parts.

I did debur the edges of the holes I put in my pressure plate which has added a bit of chamfer to the edges.

I have also been busy this week on some remaining clean up and rebuilding issues.

Since strokers powder coated bling posts have been impressive I have decided to work on my own bling by polishing my engine case with the most attention being given to the sections that will be visible once the engine is assembled. There are still some swirlies that need to be taken care of before I move on to the final stages but that' one of my chores for today. Its a shame that most of this will only be visible from underneath the car.



I also would hate to bolt that up to a grungy looking transaxle so I also cleaned it up a bit. Here are a before an after pic to show the transformation.



Old 04-30-2005, 08:04 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #178 (permalink)