Thread: 2.5 motor
View Single Post
ber911 ber911 is offline
Registered User
 
Join Date: Nov 2003
Posts: 223
I have been planning to build the same motor for some time now. The 89mm P/C are to get in under 2500cc to meet regulations. The only cost effective way to do this is JE pistons in steel sleeved cylinders but I am unable to get any opinions as to whether this setup would be inferior to JE pistons in Nickasil cylinders, and am therefore a bit hesitant to go this route at the moment.
Old 06-24-2005, 04:25 PM
  Pelican Parts Technical Article Directory    Reply With Quote #5 (permalink)