View Single Post
Mark McClure Mark McClure is offline
Registered User
 
Join Date: Jul 2002
Location: Canberra Australia
Posts: 440
tom139racing,

I did read your post and got a lot of information from it. I still need to do the solder right across the piston to see how much room I have.

Even If I have enough room across the head I still need to address the issue of the deck height and the large gap at the very permiter. I don't know if you can run without a base gasket but this would only get me an additional .25mm anyway not enough to drop the larger gap to spec. Even doing this would only decrease the smallest measurment to 1.23.

I am not too worried about the CR until I can get the deck height sorted out. Hopefully I can avoid machining the Cyl and then the head or piston.

This reduild is turning into a nightmare.

Thanks

Mark.....
Old 09-12-2005, 05:32 PM
  Pelican Parts Technical Article Directory    Reply With Quote #4 (permalink)