View Single Post
cjr1 cjr1 is offline
Registered User
cjr1's Avatar
Join Date: Mar 2005
Location: Cincinnati,Ohio
Posts: 107
Cool Engine Done...Ready to install!!!!!!

Well it's been 4,almost 5 months since pulling my 3.2 for a clutch,top end rebuild.Turned into a full rebuild in short order after coming down with the dreaded "while I'm in there" syndrome!
But after 150K+ miles,it was the least I could do!So engine is ready to go with a few extras thrown in to spiff up the looks.
While cleaning up the trans & replacing the seals I found that the release fork was cracked So much for installing this weekend.This may have also had something to do with what I thought was the clutch going out.Disk was almost to the rivets,but not quite.Must have been the fork not pulling the throw out bearing evenly.

Oh well,such is life

Here's a few pics for all you pic hounds out there!

While I'm here,any thoughts on break in oil & proper run in of cams(reground) with original rockers.I've read the various info out there & seems to be some conflicting info.

Thanks for thoughts & replies!

"If you think it's gonna cost $1000, ya better budget for $2000."

85 Carrera 3.2(Back on the road after rebuild)
02 Trans Am WS6
95 Eagle Talon
98 Bravada(sold)
07 G5
Old 09-17-2005, 12:48 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)