View Single Post
Mark McClure Mark McClure is offline
Registered User
 
Join Date: Jul 2002
Location: Canberra Australia
Posts: 440
David,

The chamfer is quite a lot. I did consider machining the heads by 0.5mm but in the end I found a head place that will weld and then machine the heads back to the 95mm. After that I will CC the heads and measure the deck height and piston 2 head clearances. If need be I can then savely machine the heads to add compression.

Thanks

Mark......

PS.......I have not found any information on the board that even mentions head work when doing a SS conversion.
Old 09-21-2005, 02:44 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #6 (permalink)