Thread: stand alone efi
View Single Post
beepbeep beepbeep is offline
Registered
 
beepbeep's Avatar
 
Join Date: Jun 2001
Location: Sweden
Posts: 5,755
Hey bug man, just did some reading on your site. "Basics of Engine Managment" was nice. There are many people on this forum that ask questions that are answered on that page.

Now few questions about M3DK:

1. Site says you have 3 ignition coil drivers...so max 6 cylinders is allowed and wastefire is used, no?

2. Are injector drivers of "Peak & hold" type and can they be attached to low-impedance drivers w/o resistors?

3. Is there Anti-lag functionality built in?

4. Is it possible to run it in MAP/Alpha-N mixed mode?

5. Is there built-in pump circuitry for direct attachment of typical WBO2-sensors (like Bosch LSU) or is only NBO2 sensor attachable?

6. Is there any launch-control functionality built in? (Programmable rev limiter triggered with latched switch on clutch, for example).


Thanx!
__________________
Thank you for your time,

Last edited by beepbeep; 10-04-2005 at 07:36 AM..
Old 10-04-2005, 07:33 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #38 (permalink)