View Single Post
sammyg2 sammyg2 is offline
Registered User
 
sammyg2's Avatar
 
Join Date: Aug 2000
Posts: 44,190
On my nikasil cylinders, I just used some solvent and some good sharp scotch-brite to clean and skuff up the bores. Basically just cleaned most of the crap out of the metal pores. No hone.
I installed new rings, no smokey. The rings seated with no drama.
YMMV.

Have you measured them to see if they are round, in spec, and don not have a step or taper?
Old 10-28-2005, 01:22 PM
  Pelican Parts Technical Article Directory    Reply With Quote #2 (permalink)