Ok, this is my problem. I started to replace the two inner wheel bearing seals on my 71 911E when I realized that the inner diameter of the seals I purchased from Vertex were to large. (approximately 42mm.) but the outer diameter was correct at approx. 64mm. So they would fit in the wheel hub, but not correctly on the spindle The inner needs diameter needs to be appox. 39mm.
I started to call around to the locate auto parts stores and was surprised to find that several of them had a listing. But upon inspection they were the same seals I had purchased from Vertex. Can anyone help me. I don't understand this.
The car has koni struts (classic's), Not sure if the car came with this type of strut or if someone did sometype of change. The car is also equiped with a 74 2.7 engine and trans. So there is a possibility that something was changed up front.
If anyone one has any ideas PLEASE let me know.
Thanks
------------------
Randy
71 911E