View Single Post
tifosiman tifosiman is offline
Registered User
 
tifosiman's Avatar
 
Join Date: Jul 2001
Location: OH USA
Posts: 670
Garage
Actually, you can cut the section of the 931 header panel out that has the four vents in it (so you have a long rectangular piece), then cut the same sort of rectangle in the 951 header panel and graft that piece in there. You'll have to do a little finish work to make it look correct, but then the vents, the curves of the openings, and the vent supports will be correct-looking. There was a guy on another forum that did this and it looked good.
__________________
1985.5 944 Club Sport


My P-caronline Profile

"A good time to keep your mouth shut is when you're in deep water. "--
Sidney Goff
Old 01-24-2006, 12:38 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #8 (permalink)