View Single Post
Capri22racer Capri22racer is offline
Registered User
 
Capri22racer's Avatar
 
Join Date: Apr 2005
Location: Ankeny, Iowa
Posts: 157
Quote:
Originally posted by tifosiman
Actually, you can cut the section of the 931 header panel out that has the four vents in it (so you have a long rectangular piece), then cut the same sort of rectangle in the 951 header panel and graft that piece in there. You'll have to do a little finish work to make it look correct, but then the vents, the curves of the openings, and the vent supports will be correct-looking. There was a guy on another forum that did this and it looked good.
Yeah, I have seen that done too. Pretty easy for body shop guy that welds and knows what he's doing.

The problem with just cutting holes a calling it day is it looks bad and cheesy. You would need to roll the edges and fabricate the mounting tabs. See pic.

__________________
1980 924 Carrera GT
1991 944S2
1984 944
Old 01-24-2006, 01:11 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #10 (permalink)