View Single Post
wirihana wirihana is offline
Registered User
 
Join Date: Mar 2003
Location: napier, new zealand
Posts: 29
F11 are what PMO recommends for e-cams, I also have some F3's which we tried with the intial set up, but got bad hesitation at about 4k rpm.

accelarator pumps have been checked, along with float levels, and carbs synched and balanced

thanks for the links. the big spikes on the dyno around 2000-2500 were from him ramping up the load a bit quick i think - we did an earlier run we did not record at it was much flatter.

At high RPM cruise (above 35000rpm) which would be at less than 1/4 throttle - does the idle circuit control the mixture? or is it the main and therefore emulsion tubes?
Old 02-01-2006, 02:05 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #6 (permalink)