Thread: Stuck camshaft
View Single Post
billd billd is offline
Registered User
 
Join Date: Dec 2005
Location: Palo Alto, CA
Posts: 203
The shoulder of the bearings of the camshaft are very square. A small chamfer on this edge would make the shaft more easily align with the bearings in the housing as it is extracted.

Is there any reason why I shouldn't file a small 45 degree chamfer on the end bearing?
__________________
Bill
1964 356 SC Coupe
1969 911 3.0L
1973 914 2.0L four & 1974 914 3.2L six, Megasquirt, twin-plug, AX car
2002 Boxster S
Old 02-07-2006, 03:35 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #6 (permalink)