View Single Post
hobieboy hobieboy is offline
Registered User
 
Join Date: May 2002
Location: Up North
Posts: 1,446
There's a tiny bit of chamford (spelling?) on the cylinders, so I measure the height between top of cylinder and the highest point (i.e. flat part) of that chamford area.

Yes, piston/valve clearance is important and I'll measure it. But, if I keep same deck height and the top end did not change (i.e. head, cam, valve, ...) then theoretically, nothing should change from last rebuild. I'd still measure it but will likely take my chance and really assemble it instead of a dry assemably.
__________________
87 930 K27HFS/B&B/Twin-Plug... Megasquirted
Old 04-11-2006, 05:55 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #11 (permalink)