View Single Post
slow&rusty slow&rusty is offline
Registered User
Join Date: May 2005
Location: Houston
Posts: 3,979
Nice work...I could tell they looked like heavily surgically worked on B&Bs, a few questions:

1) Does the car in question have to mufflers? The reason I ask is due to the very sharp and looks like a small diameter 180degree turn into the muffler, which could potentially be a bottleneck?

As an aside Burns Stainless makes these low profile mufflers (they weigh as low as 2lbs and cost about $220 and avail. in 5" O.D). I am going to try later them this spring, looks like they would have worked inline in your application negating the need for the 180degree turn:

2) Are you going to just stick on an air filter on the compressor side and clamp it to the neck? If so...any moisture concerns?

3) What turbos are you running?

Beautiful work...and would love to read the specs on this car.

Ole Skool - wouldn't have it any other way
Old 02-16-2007, 04:12 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #6 (permalink)