View Single Post
GaryR GaryR is offline
Registered User
 
GaryR's Avatar
 
Join Date: Mar 2005
Location: Valencia, Spain
Posts: 4,542
Garage
Send a message via ICQ to GaryR
Ok, been chipping away at her and she is currently in the "ready to reassemble the front end" part of the project. I'm working on both ends at the same time but will hold off on the rear until the front is done this weekend (I hope)..

Here are some pics of stuff ready to go in..

This is the front axle ready for reassembly. New Elephant polybronze bushings installed. All parts media blasted and primered/painted. Shocks are revalved Bilsteins to match up with the new 24mm hollow T-Bars. Shock paint is John Deere green, pretty good match in normal light.. New ball joints and hardware.


Closeup of the 24mm bars in place, using Mobil 1 Grease throughout.


Closer look at the polybronze and revamped parts.


Front hubs, new bearings and seals ready to go.

Smart Racing anti-roll bar in place, did it without removing the tank! New tie rods and rack boots to finish it up.
__________________
Gary R.

Last edited by GaryR; 03-16-2007 at 01:36 PM..
Old 03-16-2007, 01:30 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #9 (permalink)