View Single Post
9dreizig 9dreizig is offline
Registered User
 
9dreizig's Avatar
 
Join Date: Jul 2005
Location: Reno NV, Bay Area during most weeks,, Kids still in NH
Posts: 5,738
Send a message via AIM to 9dreizig
I just did this......

I was going to do it on the car,, and it was much easier to pull the whole unit.. Since you'll need to remove the retaning clip to get the shaft out, it's easier to do this with a press. Then of course you'll need to tap it back on over the spine,, All this is much easier when it's on a bench..

Lastly , getting the boot back on, make sure the boot and the lip of the joint ARE DRY!!!! otherwise they will slip right off ( on the car like mine did). I suggest using three vice grips to pull the boot on ( it's really a snug fit).. Also plastic tie wraps work better than the factory retaining ring ( I used two)..
Good luck!
__________________
"Todd"
98 Tahoe ,2007 Saturn Vue
86 930 black and stock, 80 930 blue tracdog
91 Spec Miata (yeah I race a chick car)
"life"ll kill ya" Warren Zevon
Old 07-03-2007, 08:56 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #3 (permalink)