View Single Post
e170drvr e170drvr is offline
Registered User
 
e170drvr's Avatar
 
Join Date: Sep 2006
Location: Evansville IN
Posts: 261
Garage
Hmm, I did not disconnect the wur power when I measured the cold pressure. with everything warmed up I got exactly 3.75 on the control pressure warm which is the figure listed in the manual. my system pressure was slightly low at 6.6 the book calls for 6.7 to 7.4. control pressure delivery was within spec at 230. manual calls for 160 to 240 cc/min. however, warm throttle enrichment with warm engine and wur pressurized at .5 bar did not cause my 3.75 warm pressure to move at all. recorded 26 ohms resistance at the wur, can't seem to get a voltage off of the power wire to the wur, should that not be battery voltage with ignition on and pumps running? thanks again for the help guys.

Eric
87 930/68
Old 09-27-2007, 08:26 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #4 (permalink)