View Single Post
Alan L Alan L is offline
Registered User
 
Alan L's Avatar
 
Join Date: Apr 2006
Location: New Zealand
Posts: 2,809
Thanks guys - at least I know where to look for the suspect wiring - something has been altered. The heater relay in the engine compartment has been looped with a piece of wire. When I pull this wire I get no fuel pumps.
It looked from wiring diagram that the second pump was looped into some type of sensor switch.
"If you pull the switch connection loose at the top of the injection housing (where the paddle and fuel distributor lives)"

I shall have to look for this one - I don't think it is there.

But I did pull the cable off my overboost switch (which is working at about 1 bar). It did not cut the pumps. According to my reckoning - if working right , it should?

They seem to be hot wired.
More hunting for dodgy bits.
Thx
Alan
Old 10-30-2007, 11:11 AM
  Pelican Parts Technical Article Directory    Reply With Quote #49 (permalink)