View Single Post
Alan L Alan L is offline
Registered User
 
Alan L's Avatar
 
Join Date: Apr 2006
Location: New Zealand
Posts: 3,185
Good suggestion - I tried it again with that in mind. It may be the air supply safety switch setting. I ran it again, and pushed the relays closed. They stayed there and I got my 12 v at the other end. I increased the idle revs and started it again, expecting it all to work. But they oscillated again at about AC rate. Maybe it has been doing this all the time.
My wiring is correct, I am sure. It is as per the factory scheme now. I removed relay jumper wires, reinstalled the safetys etc and the pumps now run from start up rather than ign on.
I will have a look at the air micro switch setting again, but I did monitor it when reinstalling the above. Had my multi meter over it watching it open/shut. I should be able to wire my meter into it's circuit with any luck.
Alan
Old 11-26-2007, 09:37 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #4 (permalink)