View Single Post
cgarr cgarr is offline
abit off center
 
cgarr's Avatar
 
Join Date: Feb 2002
Location: At the Airport Kentwood, MI
Posts: 7,148
Garage
Send a message via Yahoo to cgarr
The bushings I use are ordered from Glacier Garlock Bearings. You do not want to use any grease on these Teflon lined bushings, it will quickly use up their life span, a light oil is all that is recommended. The tool to remove the bushings is one that I made. If you are handy with a lathe you can do it. Its just a steel slug that drops in then expands so the bushing can be driven out. I am not sure if you know of this company in the UK but they list the bushing, its E4-B36-473: Bilstein 40mm Insert/Bearing, here is the link: If you want to make a tool to remove, let me know and I can get you some photos..

http://www.motorscope.co.uk/suspension.htm#Bilstein
__________________
______________________
Craig
G2Performance
Twinplug, head work, case savers, rockers arms, etc.

Last edited by cgarr; 01-11-2008 at 01:13 PM..
Old 01-11-2008, 01:11 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #15 (permalink)