View Single Post
Alan L Alan L is offline
Registered User
 
Alan L's Avatar
 
Join Date: Apr 2006
Location: New Zealand
Posts: 2,809
I can adjust the cable to take the slack out - but the fact it is slightly slack with a new friction plate suggests (to me) something is wrong internally.
I did not get an extended throw out bearing. I was very unclear what else I needed, so attached a note with the order to Pelican requesting any other parts required for the conversion. They just sent the plate. Given the plate sits in exactly the same position as the old one, with similar dimensions I could not see that this was a problem, and that I needed any other parts. Using the same pressure plate and throw out bearing as previous.
Am I missing some necessary parts? I did post a query on this board prior to ordering , but got no definitive answers.
I am increasingly sure there is already pre load on the pressure plate, but cannot see how this could have occured.
Have tried cranking engine over to see if anything 'drops' into place - no change.
Alan
Old 03-08-2008, 03:34 PM
  Pelican Parts Technical Article Directory    Reply With Quote #13 (permalink)