View Single Post
Alan L Alan L is offline
Registered User
 
Alan L's Avatar
 
Join Date: Apr 2006
Location: New Zealand
Posts: 2,809
I'm in New Zealand - a wee way away.
I used the old presure plate bolts.
The friction plate surface looked about the same as old one - altho, being new, I did not measure it.
Would it appear I have done nothing obviously wrong, and it all should work?
In which case I should be looking for something as Goran says - poor alignment?
It seemed well aligned - I made up a tool that was good to a few thou for pilot bearing and spline on clutch.
Any ideas how I can check Gorans idea?
Or should I just pull the engine and bolt it all up again.
If it is just an assembly problem, that may fix it. If it is something fundamentally wrong, I'll still have the same issue.
Thanks
Alan
Old 03-10-2008, 04:44 PM
  Pelican Parts Technical Article Directory    Reply With Quote #11 (permalink)