View Single Post
Quicksilver77 Quicksilver77 is offline
Certifiable
 
Quicksilver77's Avatar
 
Join Date: Jan 2008
Location: Folsom, CA
Posts: 194
Send a message via Yahoo to Quicksilver77
There is the third mounting point, it just didn't photo well. The gap is the problem in question. I loosened the mounting hardware reset the IC and we are back to the original starting point.
This is the "normal" gap. It is much smaller, than the first pictures, granted, but it is not completely uniform about the entire circumference. This is about as close as I could get to getting everything to sit flush. Should I give it another try to get the lip on the IC neck to sit evenly on the pipe below?







In regards to the hose clamp idea, the neck of the IC and what it slips into are both alloy, so no dice there.
It there a pressure release valve which might be sticking?
__________________
Sean D. 1987 930
India Red/Beige/Black; Mahle 3.4L; Kokeln IC; K27 7200; GHL Headers; Borla Stainless Muffler; SC cams; Sachs Aluminum Clutch; Aluminum flywheel; Bilstein Sport Shocks; Adjustable Rear Sway Bar; Weltmeister Shock Tower Brace; Lowered and Corner Balanced; MOMO RSGT Seats...
Old 03-14-2008, 10:42 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #5 (permalink)