View Single Post
Alan L Alan L is offline
Registered
 
Alan L's Avatar
 
Join Date: Apr 2006
Location: New Zealand
Posts: 3,550
Well done - they look pretty good. If you want to be finnicky - since you are in there - you could adjust #5. Unfortunately I think it is one of the harder caps to undo - depends on the angles your banjos are set at. You can loosen them off and twist slightly if necessary. You would 'tighten' the screw in the chamber by about 1/8 turn. You only need to check it against 4 and 6 since your 1-3 are in range too. But still collect the fuel in 1-3 - or else you will hydraulic the motor. These screws press on the spring that holds the little ceramic cups against the fuel head diaphragm.
Regards
Alan
Old 04-11-2008, 01:41 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #21 (permalink)