View Single Post
boostfix boostfix is offline
Registered User
 
boostfix's Avatar
 
Join Date: Nov 2006
Location: Vancouver, BC Canada
Posts: 255
Puller: Front Wheel Hub End Cap

Here is a quick (not elegant) puller that I made for getting the Front Wheel Hub End Cap off so that I could change my rotors. I was going to use a slide hammer like the Porsche manual recommends but it might rip off the threaded insert - the evidence was on the passenger side of the car where the insert has been welded back on from a previous mechanics experience! First I tried the plate by itself but it got bent pretty good without moving the end cap. After rum-aging around through the scrap steel pile I found a chunk of angle iron. No worries now! The bolt is a 10mm x 30
__________________
Dan
88 930 blk/gry
Old 06-20-2008, 08:40 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #15 (permalink)