View Single Post
NathanUK NathanUK is offline
A fellow Pelacanite
 
NathanUK's Avatar
 
Join Date: Nov 2006
Location: UK
Posts: 2,002
Garage
Here is a quote from Goran.
Quote:
You can run distibutorless ignition in two ways (actually three):

1. You use crank and cam position sensor and let EFI trigger each plug when it should..
2. You use crank sensor only and fire the plugs twice as often instead. Crank sensor doesn't know OD is in exchaust or compression phase, thus it needs to fire on every OD.
3. (This one is high-end) You use crank sensor only, fire plugs twice as often during cranking, let EFI detect ignition phase by ion-sensing and then kill unneeded phase.


MSII can be configured to use wastefire concept described above in case 1 to deliver completly distributorless ignition and fueling.

It can also be configured to work with ordinary dizzy, by recieving signal from distributor pickup and then triggering single coil.

So it's up to you.

Want to keep dizzy and coil? No problem, remove CDI box, hook the pickup into MSII, let it feed the coil and voilá, you got fully programmable ignition (and fueling, if you install injectors as well).

Want to go coilpack distributorless ignition? No problem, you remove dizzy, CDI and everything else that has with ignition to do. You let MSII feed 6-cylinder Ford EDIS wastefire coilpack.

Want distibutorless coilpack and twin plug? No problem. Buy extra Ford EDIS, connect module inputs in parallel and multiplex cables for wastefire twin-plug application.
__________________
Thank you for your time,
Goran
__________________
1981 UK 930. G50/01 shortened, 964 3.8RS Fibreglass Body Kit, 18" Alloys 8.5" F & 10" R, 225's F & 285's R, Special Colour Metallic Blue Paint, FIA Sparco Evo's, A/C and Air Pump removed, Electronic Boost Controller, GHL Headers, Tial46 WG.
Fitting - New service kit.
Needs Fitting - Innovate XD-16 Kit, Kokeln IC. Stephen's K27 HFS, EVO Intake Assy & his Modded USA Fuel Head.

1983 UK 911 3.2 Carrera Sport Coupe. Black, Black Leather with Red Piping, Black Alloy Gear Knob, K&N Air Filter Element, Turbo Tie rods.
Needs Fitting - K&N CO Sensor, Round A/F Dial Gauge, Factory Short Shift Kit.

http://www.danasoft.com/sig/Iamnotanumber.jpg
Old 06-28-2008, 04:33 AM
  Pelican Parts Technical Article Directory    Reply With Quote #2 (permalink)