View Single Post
DSPTurtle DSPTurtle is offline
Registered User
DSPTurtle's Avatar
Join Date: Jul 2001
Location: Suntree, Florida, USA
Posts: 2,231
Yup... .7MM intake valve open at TDC for number one then rotate 360 degrees and you should be at .7MM intake valve open on number four.
You absolutely cannot do this without a Z block and a dial indicator. I got mine from our host. Again, don't even think about trying to look at it and understand until you mount the Z block and dial indicator. Once you see how the measurement is taken as you spin the crank and the valve goes up and down it all will make perfect sense.
JB - BreitWerks
Engine Rebuild & Restorations
Old 07-10-2008, 09:26 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #38 (permalink)