View Single Post
Alan L Alan L is offline
Registered User
 
Alan L's Avatar
 
Join Date: Apr 2006
Location: New Zealand
Posts: 3,187
I have wondered about the cone setting. As far as I can see, the plate is set at right height - in line with top of parallel edge. However, it is fully extended upwards. If I try, I cannot lift it any higher. Should there be any remaining vertical movement beyond the rest position - is it set too high? This would seem to cause a rich response rather than lean tho - slow to allow air to follow fuel. My problem is the opposite - the fuel seems slow to follow the air.
Alan
Old 07-27-2008, 04:55 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #6 (permalink)