Thread: Engine Removal
View Single Post
rich rich is offline
Hey! Nice Rack! "Celette"
 
rich's Avatar
 
Join Date: Jan 1999
Location: Duluth Mn USA
Posts: 1,548
Garage
I made a motor creeper using low profile swivel casters with wide wheels & a 2' square scrap of 3/4" plywood. I place the rear of car on jack stands. After removing all the cables,bolts and exhaust, ect. I center a floor jack under the creeper and lower the motor. After the motor is on the floor lift the tail of the trans up, roll the jack out from under the creeper, roll the motor and trans out from under the car. Lots of ways to do this, But It works for me. BTW I do this alone.

[This message has been edited by rich (edited 09-24-1999).]
Old 09-24-1999, 07:27 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #8 (permalink)