View Single Post
x98boardwell x98boardwell is offline
After the next project
 
x98boardwell's Avatar
 
Join Date: Sep 2006
Location: Central Valley, CA
Posts: 1,517
Garage
My Bad

Nathan,

Normally I would include my model... I own an 87-930 with a B6 IC, K27S and GSF Headers. Other than that, the car is mostly stock.

The car has been running bad when cold and I was told to verify that the WUR has 12 volts to it. My IC is currently out of the car so the sensors that are normally on the IC are not currently plugged in.

Do I need to have something else on/running other than the key in the ignition to have power the the AAR and WUR and is the voltage to the green plug behind the CIS sufficient at approximately 10.4 volts?

If power should be to the AAR and WUR where is this supplied. What pin on the engine harness plug can I use to verify and is there a fuse along with these... kind of confusing and I cannot seem to find the answer when I search.

Thanks,
Old 09-27-2008, 04:06 PM
  Pelican Parts Technical Article Directory    Reply With Quote #3 (permalink)