View Single Post
x98boardwell x98boardwell is offline
After the next project
x98boardwell's Avatar
Join Date: Sep 2006
Location: Central Valley, CA
Posts: 1,529

Well, everything is off and I will be pulling my motor tomorrow to do a valve adjust along with some basic maintenance. Also, it will be much easier to put the intake and CIS system back on after I receive the injector blocks.

My Question's,

The crap in these photo's is from the underside of my fuel distributor in the air-box. I wiped it with a white paper towl so you could see the color of the residue. I also took another photo of inside then air-box (under the fuel dist.) from where the 90 degree rubber elbow normally sits. You can see the residue in the center. What does the bottom of that look like if I were to take it off?

What is this and should I do anything about it? How do I clean this area without taking off the fuel distributor?


Old 11-29-2008, 05:27 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #96 (permalink)