View Single Post
356-930 356-930 is offline
Acceleration Junkie
 
Join Date: Aug 2007
Location: Laguna Beach, CA
Posts: 263
Garage
Quote:
Originally Posted by x98boardwell View Post
Chris,

Thanks for the input. Where would you say is the best place to purchase these items? Anything to look for? Also, can you explain a little further on why for my application would the separate units work better?
A reliable source for MSD products is Summit Racing.
Link to MSD-6AL (6420) http://store.summitracing.com/partdetail.asp?autofilter=1&part=MSD-6420&N=700+400122+306213+115&autoview=sku
Link to Boost Controller MSD 8762 http://store.summitracing.com/partdetail.asp?autofilter=1&part=MSD-8762&N=700+115&autoview=sku
MSD's P/n 8762 boost control module gives you control of the boost retard start pressure and rate of retard from 1-3 deg. per psi boost (15-deg total retard max.).
The MSD 6-BTM (P/N 6462) integral ignition/boost retard system does not give you access to retard onset pressure, only rate of retard, again 1-3 deg/psi, max 15-deg retard. About $85 less than separate ign/module.

If you chose to run an MSD ignition, dig out and remove the resistor in the rotor (between coil contact and rotor out to distributor cap) and solder in its place a solid piece of 12awg copper wire (common household "romex" wire). Re-epoxy to assure the wire stays put at high rpm. Spark power is hot enough to eat the resistor.
Old 12-23-2008, 08:33 PM
  Pelican Parts Technical Article Directory    Reply With Quote #11 (permalink)