View Single Post
beepbeep beepbeep is offline
Registered User
 
beepbeep's Avatar
 
Join Date: Jun 2001
Location: Sweden
Posts: 5,562
Hello!

I wrote it in your other thread but I will cross-post it here:

3.3L engine turning @ 5500 RPM at 0.7 bar, producing 300 HP at AFR 13.0:1 (CIS goes lean on the top, remember?) at 92% VE, 50 deg. C intake temp and 29% efficiency will gulp 33,7 lb/sec of air and have per cylinder fuel flow of 262cm^3/min assuming 0.75 kg/L density and 43.8MJ/kg energy density of gasoline.

As stup did the measurements in "N/A" mode, there was no boost enrichment present, so control pressure would be still high.

In order to determine flow at boost, one must pressurize the WUR to 0.7 bar in order to dump control pressure to 2-3 bar, which will raise the injector flow over 240ml/sec.

That value is still not accurate as injectors fight against 0.7 bar of boost, which will lower injected value by couple of %.

But all in all, CIS is capable of spraying enough fuel to obtain support around 350is HP in its unmodified form. More than that and you would need to fiddle with control/system pressures (and airflow also gets impended by flapper, which is the main HP bottleneck).

Regards,
__________________
Thank you for your time,
Old 05-09-2009, 10:24 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #68 (permalink)