View Single Post
911st 911st is offline
Registered User
 
Join Date: Jan 2004
Location: Sacramento
Posts: 7,269
Mission accepted!

However there is probably an easer way. It would probably be more in the form of an adjustable metering plate. Or trial and error of fitting an air dam down into the Metering assembly bowl. How about if we trimmed the metering plate some so a dam might even be made to slip over the top and down into the pot of the end where the metering plate so quickly opens up an dumps air off the end.

Though most are not varying much from each other as to the upper target builds these days with similar cams, IC's, turbos, and boost as limited by fuel quality so one sise might fit all. It would just come wht a little richness past HP peak to those that come up lower than expected. Much better than going to lean.

This also might open up up a strategy of using a vacuum enrichment WUR like the 3.0 turbos did instead of boost enrichment for better throttle response and less of that off idle lean spot that comes with a 3.3CIS motor.
Old 09-21-2009, 12:12 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #221 (permalink)