Thread: BOOST Question
View Single Post
YZR500 YZR500 is offline
Registered User
 
YZR500's Avatar
 
Join Date: Dec 2008
Location: Chester County, PA
Posts: 330
Garage
Quote:
Originally Posted by 911st View Post
If you read vacuum at cruse or idle you are hooked up between the throttle plate and the intake valves. Your gage is seeing what your motor sees.

If you hook it up after the compressor and before the throttle plate and there is not a relief valve of some type to vent the excess pressure, you would see boost at idle and cruse.
Thanks 911st, I have read your post ...probably 20 times now,... I think it starts to sink-in now. This makes more sense to me.

So again, if I was to install water/meth injection system with my boost gauge connected where it is right now,... I would only see a little squirt here and there for less than 3-5 second at each time on a progressive injection system. I wounder if these injection system can be set to inject while the gauge reads vacuum at say a preset point of 5" mercury, which would benefit my engine while coasting???

Any thoughts
__________________
1986, 911 Carrera Cab, Turbo Look "SOLD"
1992, 964 Carrera 2, Midnight Blue
2008 BMW 550iM - 1998 BMW 318ti
2004 BMW R1100S BCR
2012 Audi TTS - APR Stage II
Old 10-21-2009, 04:41 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #16 (permalink)