View Single Post
JFairman JFairman is offline
Registered User
 
Join Date: Jul 2006
Location: S. Florida
Posts: 7,223
Get some red silicone orings that will fit in the double wall slip joint and stack some up in there and then slide the other pipe in on top of them.

Or get a large red silicone o'ring like the one that goes around the backplate on a K27 turbo. Cut it and feed it in the groove around and around. When you insert the pipe in there it will squeeze the orings down and seal the slip joint.

Another thing that should work if done well is red silicone high temp gasket sealer. Take the plastic nozzle that comes with a tube of that and cut a small hole in the end and squeeze a bunch of the red goo into the joint then put it together. that 'll take some time to squeeze enough in there to spread out and seal when you insert the pipe but it might work.
Old 11-07-2009, 02:38 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #5 (permalink)