View Single Post
Miguel Antonett Miguel Antonett is offline
Registered User
 
Join Date: Jul 2003
Location: Back in B'ham, AL
Posts: 3,416
This is what I did, a K&N filter part number is E-3270. Could not find the part number of the filter holder; but, you need a holder to perfectly fit that filter OD.

The dimensions of the filter are 160mm OD, 135mm ID and 80mm tall.

From the filter holder all you need is the top half to hold it down, the filter will seat right on the car air intake hole/throttle body (where the OEM goes) – by the plunger. You’ll need to drill two hole on the top cover to hold down the filter using the two OEM bolts. If you decide to manifold all the vents; then you’ll have to drill a hole for that connection close to the center of the holder - I did it with a 1" rubber hose and some fittings, it can be seen on the picture.

BE CAREFUL with the mix retractable adjustment needle/bolt located on the passenger side of the intake hole/throttle body. It is very flimsy and you don’t want to break it. You will have to notch the filter outer skin a bit to accommodate the needle w/o bending it.

Good luck!
Old 12-07-2009, 04:20 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #15 (permalink)