View Single Post
spoke spoke is offline
Registered User
 
Join Date: Dec 2005
Location: Allentown, PA
Posts: 666
I read all the write-ups about how to heat the trailing arm to get the outer races off.

I'm lazy and didn't feel like going through the heating cycle, so I used my Dremel tool to cut the race. One whack on with hammer and drift and its out.



Damage to the arm is minimal at best. Given that this is not a rotating mass or the slight grooves will not affect the strength at all, this damage is negligible.

Old 01-31-2010, 06:11 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #47 (permalink)