View Single Post
Twisted Minis Twisted Minis is offline
A new breed
 
Twisted Minis's Avatar
 
Join Date: Jan 2010
Location: Windsor, California
Posts: 23





Stephen brought me some blue prints for a big square thing. I wasn't entirely sure what I was building at this point really, but later came to realize Stephen did a really good job designing all the parts I built from his blue prints. His drawings where also some of the best I have gotten to work from, I get a lot of napkin drawings, or just a picture of something and "build this."





Then there was the bell housing. Again I wasn't entirely sure what was going on here, I just weld stuff. He brought in the housing pre cut, and a piece of thick 6061 angle trimmed to fit it. I welded it together after some extensive cleaning of the housing.


He took it back to his machinist at this point and had it milled down to match the flange and a hole cut for the shaft. I used the piece in the center to index the 944 section that bolts to the torque tube.

__________________
If you can find it cheaper, I can fix it!
Old 02-02-2010, 07:49 PM
  Pelican Parts Technical Article Directory    Reply With Quote #3 (permalink)