View Single Post
DonE DonE is offline
Wo ist die Rennstrecke?
 
DonE's Avatar
 
Join Date: Mar 2004
Location: Brooks, GA
Posts: 1,211
Quote:
Originally Posted by 930gt-40r View Post
Don, I would love to see some pics
Here is a pic of the magnet that that I drilled and tapped while the cam was in the motor.


This is what the adapter looks like with the sensor installed. The space around the sensor is recessed because that's how wide the GM sensor is compared to the Honeywell.


This is just a shot from the side. With the gasket, I set the gap to .040.


This is a shot of the exterior of the cam position sensor. I laid a piece of 5/16 aluminum over the original hole, welded over the hole, then drilled and tapped the hole for the Honeywell. The thread pitch on the sensor is 1 mm so each complete turn is 1 mm. Screw the sensor down until it touches the top of the magnet, then back it off 1/2 turn for .020 or one full turn for .040.
Old 02-26-2010, 06:56 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #36 (permalink)